Home Page Home Page
 Home | Linux Administration | Corporate Services | Resources | About Us Support Center
Monthly Server Management One-time Server Services Other Services
Network Administration Network Monitoring Network Security High Availability Load Balancing Data Backup and Recovery
Linux HOWTOs Linux Guides Linux Articles New RFCs Vulnerability list Linux Journal
Testimonials Partners Careers Contact Us Site Map
PLIP Install HOWTO: How did I write this howto ? Next Previous Contents

4. How did I write this howto ?

I wrote this paper during the installation process but since I encountered several problems at the same time, my notes were disparate and sometimes I forgot to write the good command lines because I was too fed up to reboot (kernel compilations) and edit this file each time.

When the installation went wrong (it did, I'm a beginner on laptops, plip, linux nfs, portmapper, Debian), I tried several things to fix the problems. When they remained too long, my brain was focused on solving, not writing.

So, when the installation process finally succeeded, I decided to restart the process from scratch by noting everything in order to save your time. It was the first time I had installed Linux twice on the same computer.

Then, in order to verify the document, I again restarted from scratch with a Slink Debian distribution (the next after the Hamm one). It was the first time I had installed Linux 3 times on the same computer. I hope it was the last time I have to do that.

Conclusion: If you do what is in this paper, it should work.


Next Previous Contents